D-Link X-STACK DES-3200 SERIES - Page 625

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
621
Parameters
<portlist> - Enter a list of ports used for the configuration here.
all - Specify that all the ports will be used for this configuration.
state - Specify that the port is a VLAN trunk port or not.
enable - Specify that the port is a VLAN trunk port.
disable - Specify that the port is not a VLAN trunk port.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure VLAN trunk ports:
DES-3200-28P:admin#config vlan_trunk ports 1-5 state enable
Command: config vlan_trunk ports 1-5 state enable
Success.
DES-3200-28P:admin#
Port 6 is LA-1 member port; port 7 is LA-2 master port:
DES-3200-28P:admin#config vlan_trunk ports 6-7 state enable
Command: config vlan_trunk ports 6-7 state enable
Success.
DES-3200-28P:admin#config vlan_trunk ports 7 state disable
Command: config vlan_trunk ports 7 state disable
Success.
DES-3200-28P:admin#config vlan_trunk ports 6-7 state disable
Command: config vlan_trunk ports 6-7 state disable
Success.
DES-3200-28P:admin#
Port 6 is LA-1 member port; port 7 is LA-1 master port:
DES-3200-28P:admin#config vlan_trunk ports 6-7 state enable
Command: config vlan_trunk ports 6-7 state enable
Success.
DES-3200-28P:admin#
Port 6, 7 have different VLAN configurations before enabling VLAN trunk.
Port 6 is LA-1 member port; port 7 is LA-1 master port.