D-Link X-STACK DES-3200 SERIES - Page 77

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
73
add - Add a server host to a server group.
delete - Remove a server host from a server group.
server_host - Server host’s IP address.
<ipaddr> - Enter the server host IP address here.
protocol - Specify the authentication protocol used.
tacacs - Specify that the TACACS authentication protocol will be used.
xtacacs - Specify that the XTACACS authentication protocol will be used.
tacacs+ - Specify that the TACACS+ authentication protocol will be used.
radius - Specify that the radius authentication protocol will be used.
Restrictions
Only Administrator-level users can issue this command.
Example
To add an authentication server host to an server group:
DES-3200-28P:admin#config authen server_group mix_1 add server_host 10.1.1.222
protocol
tacacs+
Command: config authen server_group mix_1 add server_host 10.1.1.222 protocol
ta
cacs+
Success.
DES-3200-28P:admin#
5-18 delete authen server_group
Description
This command is used to delete a user-defined authentication server group.
Format
delete authen server_group <string 15>
Parameters
<string 15> - The user-defined server group name. This value can be up to 15 characters long.
Restrictions
Only Administrator-level users can issue this command.
Example
To delete a user-defined authentication server group: