D-Link X-STACK DES-3200 SERIES - Page 9

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
5
DES-3200-28P:admin#show
Command: show
Next possible completions:
802.1p 802.1x access_profile account
accounting acct_client address_binding
arp_spoofing_prevention arpentry attack_log
auth_client auth_diagnostics auth_session_statistics
auth_statistics authen authen_enable authen_login
authen_policy authentication authorization autoconfig
bandwidth_control boot_file bpdu_protection cfm
command command_history config cpu
cpu_filter current_config ddm device_status
dhcp_local_relay dhcp_relay dos_prevention
dot1v_protocol_group dscp duld
environment erps error ethernet_oam
fdb filter flow_meter gratuitous_arp
greeting_message gvrp igmp igmp_snooping
ipif ipif_ipv6_link_local_auto iproute
ipv6 ipv6route jumbo_frame l2protocol_tunnel
lacp_port limited_multicast_addr link_aggregation
lldp log log_save_timing
log_software_module loopdetect
mac_based_access_control mac_based_access_control_local
mac_based_vlan mac_notification max_mcast_group
mcast_filter_profile mirror mld_snooping
multicast multicast_fdb nlb packet
password_recovery per_queue poe port
port_security port_security_entry port_vlan
ports power_saving pppoe pvid
qinq radius rmon router_ports
safeguard_engine scheduling scheduling_mechanism
serial_port session sim smtp
snmp sntp ssh ssl
storage_media_info stp switch
syslog system_severity tech_support terminal
tftp time time_range traffic
traffic_segmentation trap trusted_host
utilization vlan vlan_translation vlan_trunk
DES-3200-28P:admin#
In the above example, all of the possible next parameters for the show command are displayed. At
the next command prompt, the up arrow was used to re-enter the show command, followed by the
account parameter. The CLI then displays the user accounts configured on the Switch.
1-3 Command Syntax Symbols
Syntax
Description
angle brackets < >
Encloses a variable or value. Users must specify the variable or value.
For example, in the syntax