D-Link X-STACK DES-3200 SERIES - Page 95

xStack
®
DES-3200 Series Layer 2 Managed Fast Ethernet Switch CLI Reference Guide
91
delete - Specify that a profile or a rule will be deleted.
access_id - Specify the index of the access list entry. The value range is 1-256, but the
supported maximum number of entries depends on the project.
<value 1-256> - Enter the access ID used here. This value must be between 1 and 256.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure a rule entry for a packet content mask profile:
DES-3200-28P:admin#config access_profile profile_id 3 add access_id auto_assign
packet_content offset_chunk_3 0xF0 port all deny
Command: config access_profile profile_id 3 add access_id auto_assign
packet_content offset_chunk_3 0xF0 port all deny
Success.
DES-3200-28P:admin#
6-4 show access_profile
Description
This command is used to display the current access list table.
Format
show access_profile {[profile_id <value 1-4> | profile_name <name 32>]}
Parameters
profile_id - (Optional) Specify the index of the access list profile.
<value 1-4> - Enter the profile ID used here. This value must be between 1 and 4.
profile_name - (Optional) Specify the name of the profile.
<name 32> - Enter the profile name used here. This name can be up to 32 characters long.
Restrictions
None.
Example
To display the current access list table:
DES-3200-28P:admin#show access_profile
Command: show access_profile
Access Profile Table
Total User Set Rule Entries : 4