<Assembly>
1) Wipe the fuel filter mounting face with clean rag to
install a new filter.
2) Lightly oil the O-ring part.
3) Inject fuel to the new fileter to be easily discharged
an air.
4) Turn the new fuel filter until the sealing face is filted
against the O-ring.
5) Additionally tighten the fuel filter by 3/4 of one turn.
EJM1022I
- 14 -
¥
Removal
<Remover and Installer>
1) Remove filter as turning it counterclock wise.
2) Do not reuse the used filter.
¥
Assembly
1) Wipe the oil filter mounting face with a clean rag to
install a new filter.
2) Lightly oil the O-ring part.
3) Turn the new oil filter until the sealing face is fitted
against the O-ring.
4) Additionally tighten the oil filter by 3/4 of one turn.
5) Check the engine oil level and replenish to the
specified level if necessary.
6) Check the leakage at the replaced filter as
operating the engine.
1.5. Maintenance
1.5.1. Replacement of Oil Filter
Cartridge (Spin-On) Type
<Removal>
1) Remove the filter as turning it counterclock wise.
2) Do not reuse the used filter.
1.5.2. Replacement of Fuel Filter
EJM1018I
<Upword type>
Set the Filter
Wrench
Cartridge
Drain Plug
To Next Page
Loading...
