- 119 -
Maintenance Section
Typical Example
9. Tighten the locknut to 135 N
¥
m (100 lb ft), while
turning wheel hub to seat the bearing.
10. Loosen the locknut. Retorque it to 50
L
5N
¥
m
(37
L
4 lb
¥
ft). Bend the lockwasher tang to secure
locknut.
11. Install the hub cap.
12. Raise the lift truck and remove the blocking
Lower the lift truck to the ground.
Cooling System - Clean, Change
At operating temperature, the engine coolant is
hot and under pressure.
Steam can cause personal injury.
Check the coolant level only after the engine
has been stopped and the filler cap is cool
enough to touch with your bare hand.
Remove the filler cap slowly to relieve pressure.
Cooling system conditioner contains alkali.
Avoid contact with the skin and eyes to pre-
vent personal injury.
Use all cleaning solutions with care.
The lift truck must be level, the forks lowered, the
parking brake engaged, the transmission in NEU-
TRAL and the engine stopped and cool.
1. Turn the radiator cap slowly to relieve the pres-
sure, then remove the cap.
2. Remove the block drain plug.
To Next Page
Loading...
