- 97 -
Maintenance Section
Mast Channels - Lubricate
The channels on the roller-type mast require a
break-in period. Apply a light film of lubricant on
the channels where the rollers ride. This will pre-
vent metal peel until the rollers set a pattern.
Transmission Oil Level - Check
Hot oil and components can cause personal
injury. Do not allow hot oil or components to
contact skin.
1. Start and operate the lift truck until the engine
reaches normal operating temperature.
2. Park the lift truck level with the forks lowered,
parking brake applied and the transmission con-
trols in NEUTRAL.
3. With the brake applied and the engine at low
idle, shift the directional control lever to forward
and then to reverse, to fill the clutches.
4. Shift the direction control lever to the NEUTRAL
position.
5. Open the access door in floor plate.
6. Remove the dipstick/filler cap. Observe the oil
level.
7. Maintain the oil level between the ADD and
FULL marks on the dip stick/filler cap.
8. Close the access door in floor plate.
9. Stop the engine.
To Next Page
Loading...
