Operator’s Warning Plate
Located by the right side of the operatorÕs seat on
the engine compartment cover.
Identification, Lift Capacity and
Attachment Plate
Located on the cowl to the right side of the steer-
ing column.
Below are abbreviations that may appear on the
IDENTIFICATION, LIFT CAPACITY and ATTACH-
MENT PLATES and their meanings.
Mast Abbreviations
STD-Standard Mast (single inner member, low free
lift)
FF-Full Free Lift Mast (single inner member with
high free lift duplex cylinder)
FFT-Triple Lift Mast (two inner members) with
either low or full free lift characteristics.
QUAD-Quadruple (Quad) Mast (with three inner
members)
NOTE : When only a mast-type is listed on the
identification plate, a standard carriage and forks
are used.
General Section
- 38 -
IA3M1002
IA3M1001
Operator's Warning and Identification Plate
Familiarize yourself with the OPERATOR'S WARING, IDENTIFICATION, LIFT CAPACITY and ATTACHMENT
PLATES. DO NOT exceed CAPACITY AS EQUPPED load ratings.
To Next Page
Loading...
