- 101 -
Maintenance Section
Hydraulic Return Filter - Change
Hot oil and components can cause personal
injury. Do not allow hot oil or components to
contact skin.
Park the lift truck level with the forks lowered, park-
ing brake engaged, transmission in NEUTRAL and
the engine stopped.
1. Raise the hood and seat assembly. Loosen the
bolts of the hydraulic tank cover, and remove the
hydraulic tnak cover with filter assembly.
2. Remove filter assembly from the hydraulic tank
cover.
3. Install new filter assembly in the hydraulic tank
cover.
4. Inspect cover gasket for damage, replace it if
necessary.
5. Clean and Install the cover and tighten retaining
bolts.
6. Lower the hood and seat assembly.
First 250 Service Hours
You must read and understand the warnings and instructions contained in the Safety section of this manual,
before performing any operation or maintenance procedures.
IA3M4035
IA3M4037