- 100 -
Maintenance Section
6. To drain the differential housing, remove the
housing drain plug. Allow the lubricant to drain.
7. Clean and install the housing drain plug.
8. Remove the oil level plug.
9. Fill the housing with lubricant to the bottom of
the plug opening.
10. Clean and install the oil level plug or the elbow
plug.
11. Install the breather.
12. Remove the blocks from under the
carriage.Lower the carriage.
13. Operate the lift truck for a few minutes. Check
for leakes.
Parking Brake - Test, Adjust
NOTE : Be sure area around the lift truck is clear
of personnel and obstructions.
1. Drive the lift truck, fully loaded, forward up a
15% incline.
2. Halfway up the incline, stop the lift truck with the
service brake.
3. Apply the parking brake and slowly release the
service brake.
4. The parking brake should hold the lift truck. If
the lift truck starts to move, immediately apply the
service brakes. Have the parking brake adjusted.
5. Turn adjusting screw on parking lever to the left
side slightly.
6. Test the parking brake adjustment, with the lift
truck fully loaded, on a 15% incline.
7. Repeat the adjustment procedure if necessary.
To Next Page
Loading...
