- 85 -
Maintenance Section
Seat, Hood Latch & Cylinder -
Check, Lubricate
1. Check the operation of the seat adjuster rod.
Make sure that the seat slides freely on its track.
Lightly oil the seat slider tracks if necessary.
2. Push the lever down to raise the hood and seat
assembly Make certain the support cylinder will
hold the hood open.
3. Lightly oil the hood latch mechanism and the
rod for the hood support cylinder.
Fuses, Bulbs and Circuit Breaker
- Change, Reset
Fuses
NOTE : If a fuse filament separates, use only the
same type and size fuses for replacement. If the
filament in a new fuse separates, have the circuits
and instruments checked.
NOTICE
Always replace fuses with ones of the correct
ampere rating.
Remove the front cover from the fuse box are
located under the cowl.
Fuse - Protects an eletrical circuit from
an overload. Opens (filament sepa-
rates) if an overload occurs.
Typical Example
Check the fuses. Use a flashlight, if necessary.
IA3M3004
IA3M4002
IA3M4003
IA3M4004
IA3M4005
To Next Page
Loading...
