- 70 -
Operation Section
Personal injury or death could result when
towing a disabled lift truck incorrectly.
Block the lift truck wheels to prevent move-
ment before releasing the brakes. The lift truck
can roll free if it is not blocked.
Follow the recommendations below, to proper-
ly perform the towing procedure.
These towing instructions are for moving a dis-
abled lift truck a short distance, at low speed, no
faster than 2 km/h (1.2 mph), to a convenient loca-
tion for repair. These instructions are for emergen-
cies only. Always haul the lift truck if long distance
moving is required.
Shield must be provided on the towing lift truck to
protect the operator if the tow line or bar should
break.
Do not allow riders on the lift truck being towed
unless the operator can control the steering and/or
braking.
Before towing, make sure the tow line or bar is in
good condition and has enough strength for the
towing situation involved. Use a towing line or bar
with a strength of at least 1.5 times the gross
weight of the towing lift truck for a disabled lift
truck stuck in the mud or when towing on a grade.
Keep the tow line angle to a minimum. Do not
exceed a 30¡angle from the straight ahead posi-
tion. Connect the tow line as low as possible on
the lift truck that is being towed.
Quick lift truck movement could overload the tow
line or bar and cause it to break. Gradual and
smooth lift truck movement will work better.
Normally, the towing lift truck should be as large
as the disabled lift truck. Satisfy yourself that the
towing lift truck has enough brake capacity, weight
and power, to control both lift trucks for the grade
and the distance involved.
To provide sufficient control and braking when
moving a disabled lift truck downhill, a larger tow-
ing lift truck or additional lift trucks connected to
the rear could be required. This will prevent
uncontrolled rolling.
The different situation requirements cannot be
given,as minimal towing lift truck capacity is
required on smooth level surfaces to maximum on
inclines or poor surface conditions.
Consult your DAEWOO Lift Tuck dealer for towing
a disabled lift truck.
1. Release the parking brake.
NOTICE
Release the parking brake to prevent excessive
wear and damage to the parking brake system.
2. Check that the service brake pedal is released.
3. Key switch is in the OFF position.
4. Direction control lever is in neutral.
5. Fasten the tow bar to the lift truck.
6. Remove the wheel blocks. Tow the lift truck
slowly. Do not tow any faster than 2 km/h (1.2 mph).
Be sure all necessary repairs and adjustments
have been made before a lift truck that has
been towed to a service area is put back into
operation.
To Next Page
Loading...
