Safety Section
- 11 -
underneath or close to the lift truck before operat-
ing the lift truck.
Operate the lift truck and controls only from the
operator's station.
Make sure the lift truck horn, lights, backup alarm (if
equipped) and all other devices are working prop-
erly.
Check for proper operation of mast and attach-
ments. Pay particular attention to unusual noises or
erratic movement which might indicate a problem.
Make sure service and parking brakes, steering,
and directional controls are operational.
Make sure all personnel are clear of lift truck and
travel path.
Refer to the topic ÒLift Truck OperationÓ in the
ÒOperation SectionÓ of this manual for specific start-
ing instructions.
Starting the Lift truck
Do not start the engine or move any of the controls
if there is a ÒDO NOT OPERATEÓ or similar warning
tag attached to the start switch or controls.
Before Operating the Lift Truck
Test brakes, steering controls, horn and other
devices for proper operation. Report faulty perfor-
mance. Do not operate lift truck until repaired.
Learn how your lift truck operates. Know its safety
devices. Know how the attachments work.
Before moving the lift truck, look around. Start, turn
and brake smoothly.
An operator must constantly observe his lift truck
for proper operation.
Operating the Lift Truck
Always keep the lift truck under control.
Obey all traffic rules and warning signs.
Never leave the lift truck with the engine operating,
or with the parking brake disengaged.
Operate the engine only in a well ventilated area.
Lower mast, with or without load, before turning or
traveling. Tip over could result. Watch out for over-
head obstructions.
Always observe floor load limits and overhead
clearance.
Start, turn, and brake smoothly, slow down for
turns, grades, slippery or uneven surfaces.
Use special care when operation on grades. Do not
angle across or turn on grades. Do not use lift truck
on slippery grades. Travel with forks downgrade
when unloaded. Travel with load upgrade.
Do not overload, or handle offset, unstable, or
loosely stacked loads. Refer to load capacity plate
on the lift truck. Use extreme caution when handing
suspended, long, high or wide load.
To Next Page
Loading...
