- 18 -
Safety Section
The system is designed to keep the operator on the
seat and in the operatorÕs compartment in the event
of a tipover.
Inspection
1. If the seat belt is torn, if pulling motion is inter-
rupted during extension of the belt, or if the belt
cannot be inserted into the buckle properly,
replace the seat belt assembly.
2. Replace the seat belt assembly every 3 years
even if it passes visual inspection. For replace-
ment, see the date of manufacture labelled on
the back side of the belt.
3. In the event of a tipover, the seat and restraint
system should be inspected for damage and
replaced, if necessary.
The seat belt may cause the operator to bend at
the waist. If you are pregnant of have suffered
from some abdominal disease, consult a doctor
before you use the seat belt.
Fasten the Seat Belt
1. Grip the plate (connector) of the belt and pull the
belt from the retractor. Then insert the plate into
the slot of the buckle until a snap is heard. Pull
on the belt to confirm it is latched.
2. Make sure the belt is not twisted.
To Next Page
Loading...
