Safety Section
- 21 -
The load center shown on the nameplate is the hor-
izontal distance from the front face of the forks, or
the load face of an attachment, to the CG of the
load. The location of the CG in the vertical direction
is the same as the horizontal dimension.
Remember that, unless otherwise indicated, the
capacity load shown on the nameplate is for a stan-
dard lift truck with standard backrest, forks and
mast, and having no special-purpose attachment.
In addition, the capacity load assumes that the load
center is no further from the top of the forks than it
is from the face of the backrest. If these conditions
do not exist, the operator may have to reduce the
safe operating load because the truck stability may
be reduced. The lift truck should not be operated if
its capacity/nameplate does not indicate capacity
load.
NOTE : If the load is not uniform, the heaviest por-
tion should be placed closer to the backrest
and centered on the forks.
NOTICE
1. Capacity/Nameplates originally attached to
forklifts sold by DAEWOO shall not be
removed, altered or replaced without
DAEWOO’s approval.
2. DAEWOO assumes no responsibility for lift
trucks placed in service without a valid DAE-
WOO Nameplate.
3. If necessary to change your specification,
contact your DAEWOO lift truck dealer.
Safe Driving Practices
DONÕT overload. Always handle loads within the
rated capacity shown on the capacity plate.
DONÕT go over rough terrain! If unavoidable,
slow down.
INSO030S
INSO031S
To Next Page
Loading...
