(3) Measuring clearance between drive shaft and bushing
a. Measure the outside diameters of the drive shaft and driven shaft, and replace if the
measured values are less than the limit.
b. Measure the inside diameter of the pump body bushing to determine the clearance
between the bushing and shaft, and compare the measured value with the standard
value to determine whether to replace or not.
•
Reassembly
(1) For reassembly, reverse the disassembly sequence.
6.3.3.
Oil filter
ClearanceThe oil filter mounted in this
engine is of cartridge type, so it is nec-
essary to replace it with a new one at the
specified intervals.
- 159 -
MAINTENANCE OF MAJOR COMPONENTS
Standard
N
16.95 ~
N
16.968 mm
Clearance 0.032 ~ 0.077 mm
To Next Page
Loading...
