- 47 -
TECHNICAL INFORMATION
2.22.
Engine Inspection
2.22.1. Stopping engine
After checking the engine for any unusual condition at the idling speed, then turn the key
switch to stop the engine.
2.22.2.
General engine inspection cycle
2.22.3. Use of original parts for repair and replacement
For engine is being mechanically harmonized with many parts, only when the original parts
that the manufacture recommends to use is used, the engine trouble would be preventively
maintained and capable to keep up the maximum performances.
For the analogous parts not the original parts are poor in qualities and gives ill performances,
it may rather bring early engine failure
: Check & adjust : Replace
Inspection Daily
Every Every Every Every Every
Remark
50hrs 200hrs 500hrs 600hrs 1200hrs
Check for leakage(hoses, clamp)
Check the water level
Cooling Change the coolant water
System
Adjust the V-belt tension
Every
2,000hrs
Clean the radiator
Check for leakage
Lubrication Check the oil level gauge
System Change the lubricating oil 1st
Replace the oil filter cartridge
1st
Intake &
Check the leakage for
Exhaust
intercooler (hoses, clamp)
System
Clean and change
clean
the air cleaner element
Check the leakage fuel line
Clean the fuel strainer
of fuel feed pump
Remove sediment from
Fuel
fuel tank
System
Drain the water in separator
Replace the fuel filter element
Check fuel injection timing When
necessary necessary
Check the injection nozzles
When
necessary
Check the state of exhaust gas
Check the battery charging
Engine
Check the compression When
Adjust
pressure necessary
Adjust Intake/Exhaust
1st
When
valve clearance necessary
To Next Page
Loading...
