•
Apply engine oil to the entire face of
the tappets and slide them into the
tappet holes on the cylinder block.
•
Wet the cam bush inside diameter
and camshaft with oil, and carefully
assemble them while turning the
camshaft.
•
Check to see that the camshaft
rotates smoothly.
3.3.5.
Crankshaft
•
Install the main bearing machined
with two holes in the cylinder block so
that the key is aligned with the key
groove, then apply oil to the bearing
surface.
•
Heat the crankshaft gear for at least
10 minutes to 120˚C, then apply
sealant (Loctite # 641) to the inside
wall of the heated crankshaft gear
evenly before inserting it to the end of
crankshaft.
- 77 -
REASSEMBLY
To Next Page
Loading...
