3) Wear
•
Assemble the connecting rod to the crankshaft and measure connecting rod big end side
clearance using a feeler gauge.
•
Assemble the connecting rod to the piston and measure connecting rod small end side
clearance.
•
If the measured values are beyond the limit, replace the connecting rod.
3.2.
12. Fuel injection nozzle
•
Insert a seal ring and injection nozzle
on the cylinder head.
•
Measure the clearance between the
cylinder head bottom and nozzle tip. If
the measured values are beyond the
limit, replace the seal ring.
- 75 -
INSPECTION AND MEASUREMENT
To Next Page
Loading...
