DAF LF45 Series - Page 198

1SEATS
Removal and installation LF45/55 series
4-8
4.10 REMOVAL AND INSTALLAT ION, DUST BOOT
Removing dust boot
1. Remove the seat assembly.
2. Remove the seat squab.
3. Remove all cover panels.
4. Remove the air pipe to the quick-release
coupling on the connector block at the seat
rear.
5. Disconnect the attachment caps and the
clamps on the seat frame.
6. Pull the rubber dust boot at the front over
the operating lever of the horizontal seat
adjusting mechanism and the guide slides.
7. Remove the rubber dust boot completely
from the seat.
Installing dust boot
1. Fit the rubber dust boot to the seat over the
guide slides.
2. Fasten the rubber dust boot to the seat
frame (all round) using the fastening caps.
Press the attachment caps of the rubber
dust boot into the attachment holes with a
driving tool.
3. Fasten the dust boot with the clamps.
4. Fit the air pipe to the quick-release coupling
on the connector block.
5. Fit all cover panels.
6. Fit the seat squab.
7. Install the seat assembly.
7
ǹ 0210
https://www.truck-manuals.net/