Daher TBM 960 - Homesafe Deactivation

HomeSafe Deactivation 1 / 2
WARNING
HomeSafe deactivation must be performed by a pilot who is:
- fully capable of flying the airplane, and
- fully aware of all actions needed to be
performed in reconfiguring the
airplane (the flight plan in the FMS is
lost, the landing gear and flap
positions may not agree with the lever
positions for the landing gear and
flaps).
CAUTION
HomeSafe deactivation is not recommended on final approach.
1 - AP/TRIM DISC pushbutton .......................................................... Press twice
AP / YD / AT also disengage
CAUTION
MFD reconfiguration can take up to one minute. During this time, engine
instruments and CAS messages can be displayed on PFD by using DISPLAY
BACKUP
.
2 - L.H. DISPLAY BACKUP pushbutton ..................................................... Press
3 - LVL
pushbutton ..................................................................................... Press
4 - Before using VHFs, set appropriate frequency and used VHF.
5 - Inform ATC that the pilot is back and flying the airplane, and ask for altimeter
setting.
Inform that the pilot must reenter the flight plan in the
FMS
6 - Altimeter setting .............................................................................. Re-adjust
If necessary
Continue ►
Pilot's Information Manual
Section 3
Emergency Procedures
PIM TBM 960 - Edition 0
Rev. 00
Page 3.12.9
PIM - DO NOT USE FOR FLIGHT OPERATIONS