Cruise 1 / 2
1 - Altimeters setting .................................................................................. Check
2 - AP /
YD ................................................................................................ Check
Autopilot status and yaw damper ON
3 - AT ................................................................................................. As required
4 - TRQ adjustement / ITT / Ng ................................................................. Check
NOTE
Engine operation tables give TRQ to be applied according to OAT, in order not
to exceed authorized maximum power.
For maximum cruise, the FADEC automatically limits the maximum TRQ
available in accordance with the associated performance tables – refer to
Subsection 5.8. Engine Operation.
MXCR power tables are introduced depending on INERT SEP ON/OFF status
and bleed status.
5 - EIS ........................................................................................................ Check
6 - CAS display
.......................................................................................... Check
7 - Pressurization ....................................................................................... Check
Refer to
Subsection 5.4. Cabin Pressurization Envelope
8 - Fuel gauges .......................................................................................... Check
Regularly check fuel gauges for:
9
- Consumption.
10 - Expected fuel at destination.
11 - Tank automatic change every 5 minutes.
12 - Imbalance.
Maximum imbalance 15 USG
When the cruise parameters are stabilized, after 4 minutes minimum:
13 - AMPS / VOLTS ..................................................................................... Check
Continue ►
Pilot's Information Manual
Section 4
Normal Procedures
PIM TBM 960 - Edition 0
Rev. 01
Page 4.4.49
PIM - DO NOT USE FOR FLIGHT OPERATIONS
To Next Page
Loading...