Daher TBM 960 - Windshield Deicing Failure

Windshield Deicing Failure 1 / 1
Symptoms:
- windshield being covered uniformly by ice,
- no perception of heat when touching deiced section.
If symptoms result from overheat:
1 - DE
ICE SYSTEM mode switch ...................................................... MAN
All deicing systems turn on
2 - WINDSHIELD pushbutton ...................................................... OFF / ON
When necessary
In case of total failure:
3 - TEMP selector ...................................................................... Max warm
4 - DEFOG pushbutton .......................................................................... ON
Status light in green
NOTE
The demisting function is automatically switched OFF 10 minutes
after the DEFOG pushbutton has been set to ON.
Before landing:
5 - Wait for a sufficient visibility.
End of procedure.
Pilot's Information Manual
Section 3A
Abnormal Procedures
PIM TBM 960 - Edition 0
Rev. 00
Page 3A.11.4
PIM - DO NOT USE FOR FLIGHT OPERATIONS