SET PWR TO IDLE 1 / 1
Indicates that throttle is out of idle position when engine is ready for start
procedure.
CAUTION
If engine start is performed with THROTTLE out of IDLE position, the FADEC
will command a normal start sequence to reach idle, then Ng will immediately
increase to reach the power commanded by the THROTTLE (including reverse
range).
1 - THROTTLE ............................................................................................. IDLE
2 - Continue start procedure normally.
End of procedure.
Pilot's Information Manual
Section 3A
Abnormal Procedures
PIM TBM 960 - Edition 0
Rev. 00
Page 3A.3.5
PIM - DO NOT USE FOR FLIGHT OPERATIONS
To Next Page
Loading...