NOTE
If the inertial separator deploys, the MXCR schedule is automatically selected.
As a result, the FADEC changes engine ratings to the MXCR TRQ tables with
INERT SEP ON. At the same time, the maximum available TRQ is reduced
(the size of the green arc on the SEI reduces). RCR and LRCR schedules are
no longer selectable.
If the AT was active with a speed target requiring TRQ below the maximum
available TRQ, the AT will try to maintain the speed at the selected target and
then may move the THROTTLE
forward.
Torque Target Display
In MAN or FMS mode, the optimum torque index is displayed on the torque gauge.
Its display depends on
the selected cruise schedule, refer to the Garmin Pilot's
Guide, Vertical Navigation section.
If Maximum Cruise schedule is selected, a white "I" is displayed, which
corresponds to the Maximum Cruise power – refer to
Subsection 5.8. Engine
Operation.
If Recommended Cruise schedule
is selected, a green "I" is displayed, which
corresponds to the Recommended Cruise power – refer to
Subsection 5.8. Engine
Operation.
If Long Range Cruise
schedule is selected, a white "T" is displayed, which
corresponds to the Long Range Cruise power – refer to
Subsection 5.8. Engine
Operation.
Figure 7.7.2 - Maximum Cruise Torque Index
Section 7
Description
Pilot's Information Manual
PIM TBM 960 - Edition 0
Rev. 01
Page 7.7.6
PIM - DO NOT USE FOR FLIGHT OPERATIONS
To Next Page
Loading...