Local Configurations 158
Figure 5-130
Configure the settings for the HDD event. See Table 5-41. Step 2
In the Event Type list, select No HDD, HDD Error, or HDD No Space
as the event type.
Enable or disable the HDD event detection function.
Click Setting to display setting interface.
General Alarm: Enable alarm activation through the alarm devices
connected to the selected output port.
External Alarm: Enable alarm activation through the connected
alarm box.
Wireless Siren: Enable alarm activation through devices
connected by USB gateway or camera gateway.
Set a length of time for the Device to delay turning off alarm after the
external alarm is cancelled. The value ranges from 10 seconds to 300
seconds, and the default value is 10 seconds.
Select the Show Message check box to enable a pop-up message in
your local host PC.
Select the Alarm Upload check box to enable the system to upload the
alarm signal to the network (including alarm center) when an alarm
event occurs.
To Next Page
Loading...
Need help?
General