Local Configurations 263
Figure 5-243
Configure the parameters. For details, see Table 5-74. Step 2
Enable or disable the password reset function. It is enabled
by default.
If the password reset function is disabled, you can find back
the password by the security questions. Make sure you have
configured the security questions.
If you enable this function, the snapshots that are activated
by the alarm event on the Device can be sent to mobile
phone.
This function is enabled by default.
The device can access through CGI protocol.
The device can access through ONVIF protocol.
Enable or disable the audio and video stream encryption. If
enabled, make sure the devices or software support
decryption.
Table 5-74
5.20.3 Configuring System Maintenance Settings
When the Device has been running for a long time, you can configure the auto reboot when the
Device is not working. You can also configure the case fan mode to reduce noise and extend
the service life.
To Next Page
Loading...
Need help?
General