Dahua DH-XVR4104C-X User Manual

Local Configurations 205
Parameter
Description
Record CH
Select the channel(s) that you want to record. The selected
channel(s) starts recording after an alarm occurs.
The recording for IoT alarms and auto recording function must be
enabled. For details, see "5.1.4.9 Configuring Recorded Video
Storage Schedule" and "5.9.1 Enabling Record Control."
Tour
Select the check box to enable a tour of the selected channels.
To use this function, make sure the tour is enabled and configured
in Main Menu > DISPLAY > TOUR.
Voice Prompts
Select to enable audio broadcast/voice prompts in response to a
temperature alarm event.
More Setting
Show Message: Select the Show Message check box to

enable a pop-up message in your local host PC.
Buzzer: Select the check box to activate a buzzer noise at the

Device.
Video Matrix: Select the check box to enable the function.

When an alarm event occurs, the video output port outputs the
settings configured in "Main Menu > DISPLAY > TOUR."
Not all models support this function.
Send Email: Enable the system to send an email notification

when an alarm event occurs.
To use this function, make sure the email function is enabled in
Main Menu > NETWORK > EMAIL.
Log: Select the check box to enable the Device to record a

local alarm log
Table 5-52
Click Save to save the settings. Step 4
5.13.2.5 Searching IoT Information
You can search and backup all your IoT data.
To back up the data, you should prepare a USB device and plug it into the Device.
On the main interface, select IoT > SEARCH INFO. See Figure 5-179. Step 1

Dahua DH-XVR4104C-X Specifications

General

Brand	Dahua
Model	DH-XVR4104C-X
Category	DVR
Language	English