Local Configurations 50
Enable the NTP function to sync the Device time with the NTP server.
In the Server box, enter the IP address or domain name of the
corresponding NTP server.
Click Manual Update, the Device starts syncing with the server
immediately.
The system supports TCP protocol only and the default setting is 123.
In the Interval box, enter the amount of time that you want the Device to
sync time with the NTP server. The value ranges from 0 to 65535.
Table 5-4
5.1.4.4 Configuring Network Settings
You can configure the basic network settings such as net mode, IP version, and IP address of
the Device.
You can also configure network settings by selecting Main Menu > NETWORK > TCP/IP.
After you have configured the date and time settings, on the Date&Time interface, click Step 1
Next.
The NETWORK interface is displayed. See Figure 5-18
Figure 5-18
Configure the settings for network parameters. See Table 5-5. Step 2
To Next Page
Loading...
Need help?
General