Local Configurations 229
Figure 5-199
Configure the settings for the register parameters. See Table 5-66. Step 2
Enable the register function.
Enter the server IP address or the server domain that you want to
register to.
Enter the port of the server.
This ID is allocated by the server and used for the Device.
Table 5-66
Click Apply to complete the settings. Step 3
5.16.1.12 Configuring Alarm Center Settings
You can configure the alarm center server to receive the uploaded alarm information. To use
this function, the Alarm Upload check box must be selected. For details about alarm event
settings, see "5.10 Alarm Events Settings."
Select Main Menu > NETWORK > ALARM CENTER. Step 1
The ALARM CENTER interface is displayed. See Figure 5-200.
To Next Page
Loading...
Need help?
General