Dahua ITC237-PU1B-IR - Page 16

10
Parameter
Note
Manual Config
Manual config set focos parameter to focus on vehicle.
 Zoom：
 Speed：There are 3 levels.
 - and +: click to add speed, click to reduce speed； or
directly drag bar to zoom in and out.
 Focus：
 Speed：There are 3 levels.
 - and +: click to add speed, click to reduce speed； or
directly drag bar to set focus.
Note:
This function is for ITC237-PW1B-IRZ camera.
Manual config set rear focus.
 Speed：There are 3 levels.
 - and +: click to add speed, click to reduce speed； or
directly drag bar to set rear focus.
Note:
This function is for ITC237-PU1B-IR, ITC237-PU1B-L camera only.
Restore All
Restore all settings to default.
Pause/Resume
 Resume：When you click Pause. Video pauses, then click Resume to
continue playing.
 When you click Resume. Video continue playing, then click Resume to
pause.
Refresh
View latest status.
Table 2-3
Step 2. Select line type to configure. See Table 2-4.
Parameter
Note
Region
Set region to delete. Region is within red line.
Detect Line
Draw detect line of trigger of snapshot.
Detect line is green.
Shield Area
Set shield area. In this area, it will not identify vehicle plate. You can set up to
2 shield areas.
Shield area is within grey box.
Table 2-4
Step 3. In viewing field, draw lines.
Note:
Click Redraw to delete current config.
Step 4. Adjust plate snapshot position to be in the yellow box.
Try your best to make this box match actual plate position and size in the video.