●
For cameras accessed through private protocol, you can click LIVE and then enter the
username and password to play live video.
●
To lter the remote devices, you can enter all or part of device name in the Filter box.
●
To lter out the uninitialized devices, click the Not Initialized tab, and then you can
initialize the devices. For details, see "5.7.1 Initializing Remote Devices".
●
To view all remote devices added through plug and play, you can click the Not Auto
Connected tab. You can remove devices added through plug and play, and they can
be automatically added again after plug and play is enabled.
Step 3 (Optional) Enable Plug and Play.
When Plug and Play is enabled, the NVR automatically adds remote devices on the same
subnet.
●
For uninitialized remote devices, the NVR automatically initializes them before adding
them.
●
You can click set the plug and play validity period. For example, when you set the
validity period as 1 hour, the plug and play will be automatically turned o after 1
hour.
Figure 5-66 Validity period
Step 4 (Optional) Enable H.265 Auto Switch.
When H.265 Auto Switch is enabled, the video compression standard of added remote
devices is switched to H.265 automatically.
Step 5 Double-click a remote device, or select a remote device and then click Add to register it
to the Added Device list.
Related Operations
●
Change camera login password.
Select an added camera, and then click Change Camera Login Password to change the
password.
●
Show camera login password.
Select an added camera, and then click Show Camera Password to show the password.
●
Edit camera information.
On the Added Device list, click
to change the IP address, username, password and other
information.
User's Manual
183
To Next Page
Loading...
Need help?
General
