Here is for you to select working mode when hard disk is full. There
are two options: stop recording or rewrite. If current working HDD is
overwritten or the current HDD is full while the next HDD is no empty,
then system stops recording, If the current HDD is full and then next
HDD is not empty, then system overwrites the previous files.
Here is for you to specify record duration. The value ranges from 1 to
120 minutes. Default value is 60 minutes.
5.8.5.1.2 Date and time
The date and time interface is shown as in Figure 5-90.
Figure 5-90
Please refer to the following sheet for detailed information.
Here you can select date format from the dropdown list.
There are two options: 24-H and 12-H.
The time zone of the device.
It is to set system time. It becomes valid after you set.
You can click this button to save the system time as your PC current
time.
To Next Page
Loading...
Need help?
General