4 Installation Manual 3P291714-7H
DCM601B51 intelligent Touch Manager
English
WARNING
• Be sure to earth the unit.
Do not earth the unit to a utility pipe, lightning conductor or telephone earth lead.
Imperfect earthing may result in an electric shock or re.
• Do not change the protective equipment settings.
Otherwise, a short-circuit may occur in a pressure switch, temperature switch, or
other protective equipment, forcing the unit to operate unexpectedly.
In addition, use of parts other than those specied by DAIKIN may result in ring.
• Install an earth leakage breaker, as required.
Failure to install an earth leakage breaker may result in an electric shock or re.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
•
Children should be supervised to ensure that they do not play with the appliance.
CAUTION
• Be very careful about product transportation.
• Safely dispose of the packing materials.
Tear apart and throw away plastic packaging bags so that children will not play with
them.
If children play with a plastic bag which was not torn apart, they face the risk of suf-
focation.
• This unit is a class B product.
• In a domestic environment, this product may cause radio interference.
In such case, the user may be required to take adequate measures.
•
Disposal requirements Dismantling of the unit, treatment of the refrigerant, of oil
and of other parts must be done in accordance with relevant local and national
legislation.
• Fill the wiring through hole with putty.
Entry of water or insects may result in electric leakage or malfunction.
• Do not operate with wet hands.
An electric shock and malfunction may be caused.
• Do not wash this unit with water.
An electric shock or re may be caused.
• Install the indoor and outdoor units, power cord, and connecting wires at least
1 meter away from televisions or radios.
This is to prevent picture interference and noise. (Depending on the incoming signal
strength, a distance of 1 meter may not be sufcient to eliminate noise.)
• Do not install the unit in the following places.
1. Where there is a high concentration of mineral oil spray or vapor (e.g. a kitchen).
Plastic parts will deteriorate, parts may fall off and water leakage could result.
2. Near machinery emitting electromagnetic radiation.
Electromagnetic radiation may disturb the operation of the control system and result
in a malfunction of the unit.
3. Where ammable gas may leak, where there is carbon bre or ignitable dust
suspensions in the air, or where volatile ammables such as paint thinner or
gasoline are handled.
Operating the unit in such conditions may result in re.
4. High temperature area or directly amed point.
Abnormal heat build-up or ring may be caused.
5. Moist area, or place that may be exposed to water.
If water enters inside the unit, an electric shock and malfunction may be caused.