The following settings only apply if "Power meter" was selected in
point 3.
Pulse input
Pulse setting
This is where you set the number of pulses that can be received
before one unit is counted out. The unit is given in kW.
NB. Only inputs 1 and 2 can be used for pulse counting.
Scaling factor
The reading from the unit can be corrected with a factor so that
the readout becomes more comprehensible.
KWh = scaling factor/pulses per KWh
Start value/Reset reading
This is where you select a start value or reset the accumulated
value of the power meter.
On the next line you can see the date and time of the setting.
This list of settings was
previously covered under
temperature. Please see the
explanation on pages 24-25.
The previous day’s power consumption
This is where you can read the power consumption for the pre-
vious 24 hours.
Consumption from 0:00 to 24:00.
Power consumption for the past week
This is where you can read the power consumption for the past
week.
Power consumption from Monday at 0:00 to Sunday at 24:00.
To Next Page
Loading...
