This is where you set who or what can be enabled in the event of
an alarm. Below you will see an overview of the destinations. The
settings are shown on the next few pages.
Remote
destination
Buzzer in monitoring unit
Remote destination
via SMS
Data can be set on up to four destinations, that are to be connected via
a modem or TCP/IP. The settings are described overleaf.
Will only be set if the buzzer is to
be used in an alarm situation. The
settings are described three pages
on from here.
Data can be set on up to
three destinations.
The settings are described
three pages on from here.
Alarm destinations
Overview
To Next Page
Loading...
Need help?
General
