When there is an alarm
Daily use
When there is an alarm, an alarm symbol will appear by the point
from which the alarm originates. At the same time, the LED by the
alarm button will ash.
By pressing the alarm button in this situation, all active alarms will
be displayed.
Select one of the alarms and then press the "Enter" button. You
will now see more information about the alarm.
Now the alarm has been seen, it is up to you to make sure that
someone does something about it to correct the error.
Later on, when the error has been rectied, the alarm shown will
be cleared from the "Active alarms" screen. But you will always be
able to find it in the "Alarm history" screen.
(The Alarm history screen is "one push to the right" of the Active
alarms screen.)
Further on to the right is the "Event log" screen, i.e. who, when
and what has been done.
You can also see here when an alarm was confirmed.
(Only for trained personnel.)
Page 1
Page 2
Page 3
You can do the following when the alarm
sounds:
• Press the alarm button twice and the noise
will stop
• Look through the list of the active alarms
• Take action to deal with the error
To Next Page
Loading...
