Danfoss FC 300

2.2. Parameter Selection
Parameters for FC 300 are grouped into various parameter groups for easy selection of the correct
parameters for optimized operation of the frequency converter.
0-xx Operation and Display parameters
• Basic Settings, set-up handling
• Display and Local Control Panel parameters for choosing readouts, setting up selections
and copying functions
1-xx Load and Motor parameters includes all load and motor related parameters
2-xx Brake parameters
•DC brake
• Dynamic brake (Resistor brake)
•Mechanical brake
•Over Voltage Control
3-xx References and ramping parameters includes DigiPot function
4-xx Limits Warnings; setting of limits and warning parameters
5-xx Digital inputs and outputs includes relay controls
6-xx Analog inputs and outputs
7-xx Controls; Setting parameters for speed and process controls
8-xx Communication and option parameters for setting of FC RS485 and FC USB port parameters.
9-xx Profibus parameters
10-xx DeviceNet and CAN Fieldbus parameters
13-xx Smart Logic Control parameters
14-xx Special function parameters
15-xx Drive information parameters
16-xx Read out parameters
17-xx Encoder Option parameters
2. How to Programme FC 300 Programming Guide
26 MG.33.M2.02 - VLT
®
is a registered Danfoss trademark
2