Danfoss TTS350 User Manual

Figure 6-1 Module Removal
5. RemovetheMotor-CoolingValveSolenoidCoilsbyremovingtheretainingnutoneachsolenoid.
• • • CAUTION • • •
ThesolenoidactuatorsarededicatedonallmodelsexceptTT300/TG230.Noteactuatorpositionbeforeremoval.

6. Dryoffanycondensatearoundthesolenoids.
Figure 6-2 Motor Cooling Valve Solenoids
7. RemoveanydebrisordustfromBackplaneBoardandsolenoidsusingasoft-bristlebrush.
6.2.1.2 Service Side Assembly
1. Applyathincoatingofdielectricgreasetotheexteriorofthebearingsensorfeedthroughconnectors.

M-SV-001-EN Rev. H-1/23/2023 Page 277 of 294

Danfoss TTS350 Specifications

General

Brand	Danfoss
Model	TTS350
Category	Air Compressor
Language	English