Danfoss VLT AutomationDrive User Manual

5.6 Remote Programming with MCT 10 Set-
up Software
Danfoss has a software program available for developing,
storing, and transferring frequency converter programming.
The MCT 10 Set-up Software allows the user to connect a PC
to the frequency converter and perform live programming
rather than using the LCP. Also, all frequency converter
programming can be done off-line and simply downloaded
into frequency converter. Or the entire frequency converter
profile can be loaded onto the PC for back up storage or
analysis.
The USB connector or RS-485 terminal are available for
connecting to the frequency converter.
MCT 10 Set-up Software is available for free download at
www.VLT-software.com. A CD is also available by requesting
part number 130B1000. A user’s manual provides detailed
operation instructions.
About Frequency Converter P...
VLT
®
AutomationDrive Operating
Instructions
40 MG.33.AJ.02 - VLT
®
is a registered Danfoss trademark
5
5

Danfoss VLT AutomationDrive Specifications

General

Supply Voltage	3 x 200-240 V ±10% 3 x 380-500 V ±10% 3 x 525-600 V ±10%
Enclosure	IP20
Output Power Range	0.25 kW - 1.5 MW
Communication Protocols	Modbus RTU
Protection Features	Overcurrent, Overvoltage, Undervoltage, Short circuit, Ground fault, Motor overload
Ambient Temperature Range	-10°C to +50°C (14°F to 122°F)