Danfoss vlt FC 102 Instruction Manual

4.9 Installation Check List
23
5 Commissioning
24
5.1 Safety Instructions
24
5.2 Applying Power
24
5.3 Local Control Panel Operation
25
5.4 Basic Programming
28
5.4.1 Commissioning with SmartStart 28
5.4.2 Commissioning via [Main Menu] 28
5.4.3 Asynchronous Motor Set-up 29
5.4.4 Permanent Magnet Motor Set-up 29
5.4.5 Automatic Energy Optimization (AEO) 30
5.4.6 Automatic Motor Adaptation (AMA) 30
5.5 Checking Motor Rotation
31
5.6 Local Control Test
31
5.7 System Start-up
32
5.8 Maintenance
32
6 Application Set-up Examples
33
7 Diagnostics and Troubleshooting
39
7.1 Status Messages
39
7.2 Warning and Alarm Types
41
7.3 List of Warnings and Alarms
42
7.4 Troubleshooting
49
8 Specifications
52
8.1 Electrical Data
52
8.1.1 Line Power Supply 3x200–240 V AC 53
8.1.2 Line Power Supply 3x380–480 V AC 55
8.1.3 Line Power Supply 3x525–600 V AC 57
8.1.4 Line Power Supply 3 x 525–690 V AC 59
8.2 Line Power Supply
62
8.3 Motor Output and Motor Data
62
8.4 Ambient Conditions
63
8.5 Cable Specifications
63
8.6 Control Input/Output and Control Data
64
Contents
VLT
®
HVAC Drive Instruction Manual
MG11AJ22 - Rev. 2013-09-13

Danfoss vlt FC 102 Specifications

General

Category	DC Drives
Model	Danfoss VLT FC 102
Output voltage range	0 to rated motor voltage
Power range	0.37 kW to 200 kW
Communication interfaces	RS-485
Protection features	Overvoltage, undervoltage, overcurrent, short circuit, earth fault, overtemperature, motor thermal protection
Cooling method	Air-cooled
Enclosure rating	IP20, IP21, IP55 (depending on model)
Approvals	CE, UL, cUL