Dascom 5130P - Enable;Skip Listing Current Settings; Language Selection; Restore Factory Defaults

Tally Dascom 5130P
31
4.1 Enable/Skip listing current settings
1) With the cover closed, hold 【USER1】+【USER2】 while powering on until the printer resets and beeps
3 times. LED”DATA” lights up and LED”ON/PAPER” blinks to indicate the activation of Setup Menu
mode.
2) Load an A4 paper. The printer will automatically print as below.
【USER1】prints the listing 【USER2】skips the listing
3) Press 【USER1】 to print out current settings. Continue to load A4 paper until all the setting items are
listed out.
4) Then the printer will print:
Current Setting: Common Setup
【USER1】=OK 【USER2】=Next 【OFFLINE】=Exit
5) Press 【USER1】 to enter “Common Setup” while pressing 【USER2】 to print out the next option
“System Setup”. Press 【OFFLINE】to exit current setting.
4.2 Language Selection
1) With the cover closed, hold 【USER1】+【USER2】 while powering on until the printer resets and beeps
3 times. LED”DATA” lights up and LED”ON/PAPER” blinks to indicate the activation of Setup Menu
mode.
2) Load an A4 paper. The printer will automatically print as below.
【USER1】prints the listing 【USER2】skips the listing
3) Press【USER2】 to skip listing current settings. The printer will print as below:
Current Setting: Common Setup
【USER1】=OK 【USER2】=Next 【OFFLINE】=Exit
4) Press 【USER1】 to enter “Common Setup”. Press 【USER1】 again, it prints out current language
selection. Repeat to press 【USER2】 until the required language is printed out. Press 【USER1】 to
confirm the selection. Once confirmed, subsequent dialogs will be printed in the selected language.
4.3 Restore Factory Defaults
1) With the cover closed, hold 【USER1】+【USER2】 while powering on until the printer resets and beeps
3 times. LED”DATA” lights up and LED”ON/PAPER” blinks to indicate the activation of Setup Menu
mode.
2) Load an A4 paper. The printer will automatically print as below.
【USER1】prints the listing 【USER2】skips the listing
3) Press【USER2】 to skip listing current settings. The printer will print as below:
Current Setting: Common Setup
【USER1】=OK 【USER2】=Next 【OFFLINE】=Exit
4) Press 【USER1】 to enter “Common Setup”. Press 【USER2】 twice to print out “Default Set”. Press
【USER1】 to select corresponding item to restore factory default.