Tally Dascom 5130P
34
4.6.2 System Setup
Parameter
group
Parameter Possible settings Description
Emulation ESC/P2*(Menu1)
Olivetti*(Menu2)
IBM
Selects the emulation for the printer.
T5023
Compatible
(1)
No *
Ye s
Selects if the printer is compatible to the T5023 printer or not.
Buzzer No *
Ye s
PE Off
Selects if the buzzer sounds on hardware errors or not.
PE Off: only invalid for paper end alarm
Line Wrap
(1)
No *
Ye s
Specifies how to deal with the extra characters when the
received characters exceed the printable columns per line.
Yes: print the remaining characters in the next line
No: ignore the remaining characters
Media
(1)
Single ply *
Multi-part
Thin Form
Bankbook
Passport
Specifies the media type.
Single ply: prints with normal impact strength of the print head,
at max. 400CPS print speed.
Multi-part: prints with heavier impact strength of the print
head, at max. 300CPS print speed.
Thin Form: decrease the paper feed speed from 7ips to 5ips,
so as to prevent paper jam
Bankbook: max. thickness is 2mm, at max. 400CPS print
speed.
Passport: max. thickness is 6mm, at max. 300CPS print speed.
Auto CR
(2)
Yes
No *
Switches the automatic carriage return on (Yes) or off (No) after
receiving the signal Line Feed (LF).
No: LF=LF, line feed only
Yes: LF=LF+CR, carriage return and a line feed
Auto LF
(1)
Yes
No *
Switches the automatic Line Feed on (Yes) or off (No) after
receiving the signal Carriage Return (CR).
No: CR=CR, carriage return only
Yes: CR=CR+LF, carriage return and a line feed
High Speed Yes
No *
Yes: prints 10cpi HS-Draft with 400CPS on max. 8.4inches
width media, and prints graphics in 90x180 DPI.
No: prints Draft speed only, and prints graphics in 180x180 DPI.
Eject Dir
(1)
Front *
Rear
Selects the paper eject direction.
Front: ejects paper to the front
Rear: ejects paper to the rear
System
Setup
Paper Eject
(1)
Hold *
Drop
Selects the paper position after paper ejection.
Hold: The paper is not fully ejected but held by the transport
rollers.
Drop: The paper is fully released by the paper transport
mechanism so it can fall in a basket.
(1)
Invalid in Olivetti emulation.
(2)
Invalid in Epson ESC/P2 emulation.
To Next Page
Loading...
