Tally Dascom 5130P
56
mechanical functions before this signal enters ready state, or it may cause damage to the printer.
FAULT¯¯¯¯¯¯
Signal to indicate error condition. Low logic level is effective. The signal turns to low logic level in the
following case:
z Paper out
z Error or defective condition
FUSE
Signal connect to +5V through 3.3KΩ resistance.
SLCTIN¯¯¯¯¯¯¯¯ （Valid for Epson ESC/P2 emulation only）
When the signal is low logic level, no DC3 control code or DC1 control code is received.
To Next Page
Loading...
