Chapter 14. Installation Guide
14.1. Installing the Switch in a Rack
The switch can be installed in a 19" rack. The brackets used to fix the device already come attached to the
switch. To install the switch in a rack, use the following procedure and refer to the figure below:
Figure 14-1. Rack Mounting
14.2. Powering the Switch
Warning
Remember to attach the ground to chassis before installing a suply source.
After installing the switch, plug one end of a IEC-320 standard power cable into the AC receptacle located
at the rear panel of the switch and the other end into the local power source outlet. The Power LED should
light, indicating the switch is correctly powered.
38
To Next Page
Loading...