6-52 Magellan
®
9500
EAS Retry Count
This feature sets the number of times the deactivation sequence (defined
by the feature, “EAS Deactivation Duration — Retry ”) is restarted after a
failed deactivation attempt.
To set the EAS Retry Count:
1. Scan the SWITCH bar code.
2. Scan the bar code,
SET EAS RETRY COUNT below. You’ll need to
cover any unused bar codes on this and the facing page to ensure
that the scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the keypad in Appendix C that rep-
resent the desired number. The selectable range is 0-15 resets. Pad
all single and double digit numbers with leading zeroes to yield a
two-digit entry (00-15).
4. Complete the programming sequence by scanning the SWITCH
bar code.
SET EAS RETRY COUNT
NOTE
A setting of zero specifies no deactivation retries upon failed deactivation
attempt.
To Next Page
Loading...
Need help?
General
