6-164 Magellan
®
9500
Enable EAN Two Label
Enables/disables the ability of the scanner to decode EAN two-label pairs.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover
any unused bar codes on this and the facing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
EAN TWO LABEL = DISABLE
EAN TWO LABEL = ENABLE
Table 6-2
Contact Customer Support for details about advanced programming for this fea-
ture.
To Next Page
Loading...
