Error Codes
Product Reference Guide 4-3
Error Codes
If an error is detected, the scanner will sound a long low tone (for one sec-
ond) and alternately flash its LEDs, indicating a failure. Following the
long low tone, an error code will appear on the 7-segment display (refer to
Figure 4-1). Pressing the Volume/Tone Push button will cause the scanner
to sound a series of beeps corresponding to that error code. The table on
the following page describes what these codes mean and what action
should be taken for each.
NOTE
When troubleshooting, always remember to check all cable connections
first before proceeding with other problem isolation steps.
To Next Page
Loading...
Need help?
General
