6-54 Magellan
®
9500
Manual EAS Deactivation Push Button — continued
Remember to cover any unused bar codes on this and the facing page to
ensure that the scanner reads only the bar code you intend to scan.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan your selection from the bar codes below. You’ll need to cover
any unused bar codes on this and the facing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
MANUAL EAS DEACTIVATON PUSH BUTTON = DISABLE
MANUAL EAS DEACTIVATON PUSH BUTTON = ENABLE ALWAYS
To Next Page
Loading...
