Compatibility with PM8300
14
PowerScan™ PD9330/PBT9300/PM9300
CHANGING DEFAULT SETTINGS
Once your reader is setup, you can change the default parameters to meet
your application needs. Refer to the preceding paragraphs for initial config
-
uration in order to set the default values and select the interface for your
application.
In this manual, the configuration parameters are divided into logical groups
making it easy to find the desired function based on its reference group.
The first four groups are for Standard Interface parameter configuration for
all PowerScan™ D8330 series readers and PowerScan™ M8300/BC-80X0
Standalone configurations only:
•RS-232
•USB
•WEDGE
• NETWORK PARAMETERS are available only for BC-8060 Network config-
urations.
The following parameter groups are common to all interface applications:
• DATA FORMAT parameters regard the messages sent to the Host sys-
tem for all interfaces except Pen Emulation.
• POWER SAVE manages overall current consumption in the reading
device.
• READING PARAMETERS control various operating modes and indicator
status functioning.
• DECODING PARAMETERS maintain correct barcode decoding in certain
special reading conditions.
•CODE SELECTION parameters allow configuration of a personalized mix
of codes, code families and their options.
• ADVANCED FORMATTING PARAMETERS allow code concatenation and
advanced formatting of messages towards the Host. It cannot be used
with Pen Emulation connections.
• RADIO PARAMETERS (M8300 series only) allow configuration of radio
control parameters.
• DISPLAY PARAMETERS (some M8300 series models only) allow configu-
ration of reader display parameters.
To Next Page
Loading...
Need help?
General
